SUPERB STRENGTH
TUESDAY — BACK SQUAT
SESSION INTENT
Build lower-body strength through controlled, technically consistent back squats. The focus is strong positioning, bracing and repeatable sets at the same quality throughout the session.
Main lift: 3 REPS × 5 SETS — EVERY 2:00
COACHING PRIORITIES
Establish a stable stance and consistent squat depth.
Brace the core before every repetition.
Keep the whole foot grounded and knees tracking in line with the toes.
Maintain a strong, stable torso throughout the squat.
Increase load gradually during the preparation sets.
Choose a working weight that allows all five sets to be completed with good technique.
MOVEMENT STANDARDS
Back Squat
Bar rests securely on the upper back.
Feet remain planted throughout the movement.
Hips descend below the top of the knees, where mobility and control allow.
Knees track in line with the toes.
Finish each rep standing tall with hips and knees extended.
SCALING
Adjust the load to the athlete's experience and movement quality. Athletes who cannot maintain a stable position should reduce the load or use a suitable squat variation.
ACCESSORY — EMOM 6
40 sec work / 20 sec transition:
Dumbbell Lunges
Weighted High Step-Ups
Standing Calf Raise
Repeat from minute 1
Coach controlled repetitions, stable knees and a full range of motion. Athletes should select loads that allow them to work consistently for the full 40 seconds.
COACH'S FOCUS
Prioritise technique over load. Watch bracing, foot pressure and knee position, especially as athletes increase weight. Every set should look controlled and consistent.
SUPERB INTENSITY
TUESDAY — RUN & DUMBBELL CONDITIONING
WORKOUT
4 ROUNDS FOR TIME — TIME CAP 20 MIN
400m Run
40 Alternating Dumbbell Snatches
30 Sit-Ups
20 Burpees
Loading — Single Dumbbell Snatch
RX: 22.5 / 15 kg
I: 15 / 10 kg
S: 10 / 7 kg
SESSION INTENT
A conditioning workout combining running, unilateral power, trunk endurance and burpees. Athletes should aim for a steady pace and efficient transitions, keeping enough energy to maintain their running speed across all four rounds.
TARGET STIMULUS
Duration: 12–20 minutes
Effort: Moderate to high
Primary focus: Repeatable rounds and aerobic capacity
Strategy: Run at a pace that can be sustained, then work through the dumbbell snatches in manageable sets.
MOVEMENT STANDARDS & COACHING CUES
Run — 400m
Start at a sustainable pace.
Keep shoulders relaxed and breathing controlled.
Aim to maintain a similar pace across all four rounds.
Alternating Dumbbell Snatches — 40 Reps
Each rep starts with the dumbbell on the floor.
Drive through the legs and hips to bring the dumbbell overhead in one continuous movement.
Finish with the elbow locked out and the dumbbell controlled overhead.
Alternate arms each rep.
Keep the dumbbell close to the body and avoid excessive twisting.
Sit-Ups — 30 Reps
Use a consistent range of motion on every rep.
Keep the movement controlled rather than relying entirely on momentum.
Scale the range of motion if needed.
Burpees — 20 Reps
Lower the chest to the floor.
Return to standing under control.
Finish with a small jump and hands overhead, unless the prescribed variation specifies otherwise.
Maintain a steady rhythm rather than sprinting the first set.
PACING & STRATEGY
Round 1: Find a sustainable pace; do not sprint the run.
Rounds 2–3: Break dumbbell snatches into manageable sets and keep transitions short.
Round 4: Increase effort if technique and running pace remain consistent.
SCALING
Reduce the run distance if needed.
Use a lighter dumbbell while maintaining control overhead.
Reduce sit-up volume or use a suitable abdominal variation.
Scale burpees to step-back burpees if jumping or floor transitions become difficult.
COACH'S FOCUS
Watch dumbbell control overhead, especially when athletes are fatigued from running. Encourage consistent breathing and smart breaks. The aim is to keep moving through all four rounds without sacrificing movement quality.
The goal: Consistent rounds, efficient transitions and strong technique from the first run to the final burpee.
Clarify the back squat loading planCorrect the accessory EMOM structure




